Tag: 26 pin

Converts the CPC 6128's internal 26-pin floppy connection to a standard 34-pin Shugart interface.

The Lotharek page exposed a login-or-register-to-buy path on 2026-07-27. Installation requires soldering the adapter in place of the original flat cable. A replacement drive or HxC emulator is not included, and the attached device still needs the correct configuration, power, mounting, and media setup.

Adds SAM2695 General MIDI synthesis to a sound card with a compatible Wave Blaster header.

The Lotharek page exposed a login-or-register-to-buy path on 2026-07-27. It identifies the sound-card wavetable header but does not publish a tested-card list, connector-orientation diagram, clearance envelope, or host mixer and software setup. Confirm that the sound card has a correctly keyed or clearly marked Wave Blaster-compatible 26-pin header, identify pin 1, check daughterboard clearance, and power off before installation. Do not assume an arbitrary 26-pin connector is compatible.

Brings an Ultimate64 replacement board's internal user-port header to a C64-style edge connector with the power rails needed by compatible peripherals.

The 1541 Ultimate store listed version 2.0 for EUR 9.98 but out of stock on 2026-07-30. The flat cable is included. The official documentation warns that the connector has only one correct orientation: its red wire must align with pin 1, and a shifted or reversed connection can damage the board or accessory. The header's extra pins can drive either 9 VAC generation or an APA102C LED strip; the documentation says 9 VAC is enabled when LED-strip use is off. Do not assume this earlier Ultimate64 adapter is interchangeable with Commodore's separate C64U User Port Adapter.