Tag: modern host

Streams read-only floppy images from a modern USB host to compatible 34-pin drives or an Amiga external-floppy adapter.

The standalone unit, cable set, and Ami2PC bundle exposed current login-or-register-to-buy paths on 2026-07-27. The official HxC home page and release notes show that the software project remains active in 2026. The unit needs a modern computer running the HxC host software and emulates disks read-only. The standalone set includes a 40 cm floppy ribbon and USB A-to-B cable; Ami2PC instead adds the Amiga external-floppy adapter. Never connect or disconnect the 34-pin or Amiga-side cable while USB is attached; disconnect USB first. Ami2PC can use Amiga disk-copy software to write a real disk in DF0 from an emulated DF1. Its early-boot workflow needs Kickstart 2.0 or newer. The seller still does not identify which oldest Amigas need its unspecified modification, so do not rely on early-model boot support without separate instructions.

Connects Atari SIO computers to a modern USB host, with 10502PC variants that can also image disks through a physical Atari drive.

The basic SIO2PC USB, 10502PC Revision 2, and USB-C Revision 3 pages all exposed login-or-register-to-buy paths on 2026-07-27. Host emulation requires a modern computer, FTDI serial drivers where needed, and software such as RespeQt or AspeQt. The basic interface's manual uses DSR handshaking, while the 10502PC pages specify CTS for SIO2PC mode. Physical-drive imaging requires a 10502PC variant, ALibPC, and the documented FTDI setup; launching ALibPC changes the adapter to 10502PC mode, and unplugging and reconnecting USB restores its default SIO2PC mode.

Connects an Atari 8-bit computer to a modern Mac or Windows computer for disk, cassette, modem, printer, and file-transfer emulation.

The Atari 8-bit collection marked all versions sold out on 2026-07-24. Dual-SIO versions can sit within an SIO chain; single-SIO versions must be at the end or on a splitter. All listed versions include a printed case and an 8 GB microSD card, but need a separate Micro-USB host cable and a Mac or Windows computer. Windows may also need a UART driver.

Bridges a modern computer over USB serial to Commodore IEEE-488 and IEC equipment, or supplies host-backed storage to a Commodore computer.

The maintainer explicitly calls XS1541 orphaned and reconstructed its documentation from an archived build guide. The surviving page provides a schematic, firmware, and detailed assembly and flashing steps, but not a turnkey current kit. The original board connector footprints are buggy: the narrow connector can short contacts unless the coding gap is physically corrected. A build also requires fine-pitch FT232RL soldering, ATmega programming, fuse setup, cables, and suitable host software.

USB interfaces that connect Commodore IEC disk drives to a modern computer for disk transfer and archival.

Retro Electronics listed two assembled USB-C compatible boards in stock on 2026-07-25. The reference ZoomFloppy hardware files are openly published. Required USB and Commodore drive cables are not supplied with either documented route, and parallel-transfer features need additional drive-side hardware.