Tag: file transfer

4 matching upgrades

Showing 4 products.

StatusProductWhat it doesCompatibilityLinks
Build itChecked Jul 27, 2026Apple2-IO-RPiby TJ Boldt

Connects a Raspberry Pi Zero 2 W to an enhanced Apple IIe for virtual disks, networking, Linux commands, and file transfer.

The upstream project describes Revision 7 as a prototype rather than a finished product. Most development and testing used an enhanced Apple IIe with the card in slot 7; the firmware assumes the slot 3 80-column card and lowercase support. A Pi Zero 2 W can consume roughly 170 to 250 mA from the Apple II's 500 mA total slot budget. Revision 6 and later can use external USB power after the documented jumper change, but the firmware will hang if the Pi is not powered.

Sources
  • Apple IIe Exact model
AvailableChecked Jul 24, 2026TashTalk USBby Feral Firmware and Tashtari

Connects a modern Mac or Linux computer directly to vintage LocalTalk computers and peripherals over USB.

JCM showed 181 assembled units in stock on 2026-07-24. A standard Macintosh crossover serial cable or a LocalTalk dongle is still required; a straight-through serial cable will not work. TailTalk describes itself as a work-in-progress prototype and currently expects a routerless AppleTalk setup.

Sources
  • LocalTalk bridges Bus/interface
Build itChecked Jul 25, 2026XS1541by Nils Eilers and Andre Fachat

Bridges a modern computer over USB serial to Commodore IEEE-488 and IEC equipment, or supplies host-backed storage to a Commodore computer.

The maintainer explicitly calls XS1541 orphaned and reconstructed its documentation from an archived build guide. The surviving page provides a schematic, firmware, and detailed assembly and flashing steps, but not a turnkey current kit. The original board connector footprints are buggy: the narrow connector can short contacts unless the coding gap is physically corrected. A build also requires fine-pitch FT232RL soldering, ATmega programming, fuse setup, cables, and suitable host software.

Sources
  • Commodore PET series Stated family
  • Commodore 64 Exact model
  • Commodore VIC-20 Exact model
  • Commodore 128 Exact model
AvailableChecked Jul 27, 2026ZoomFloppy and XUM1541 Familyby Nate Lawson, RETRO Innovations, and compatible-board makers

USB interfaces that connect Commodore IEC disk drives to a modern computer for disk transfer and archival.

Retro Electronics listed two assembled USB-C compatible boards in stock on 2026-07-25. The reference ZoomFloppy hardware files are openly published. Required USB and Commodore drive cables are not supplied with either documented route, and parallel-transfer features need additional drive-side hardware.

Sources
  • Floppy preservation hardware Bus/interface