Tag: kicad

Provides an open build for selecting either Commodore 64 control port from one Atari-style joystick, with optional second-fire and autofire circuits.

The repository supplies KiCad files, Gerbers, a schematic, bill of materials, and assembly guidance. Inspect the completed board for solder bridges and support it while pressing its buttons. Never move jumpers while powered or map two physical inputs to the same function. Do not connect a Sega Genesis or Mega Drive controller; the maker warns that it may damage the C64 and directs those controllers to the separate Mega Switcher.

A buildable C128 and IBM CGA digital-to-analog video adapter with RGBS, RGBHV, and Commodore A/V pass-through options.

The repository publishes KiCad sources, Gerbers, a BOM, and printable cases for revision 1.3. The maker tested RGBI, composite, S-Video, audio, and GBS-Control output; revision 1.3 corrects the earlier monochrome pass-through error. This is not a scan converter. Use a compatible 15 kHz path such as GBS-Control or a suitable SCART converter. Never connect the C128 A/V power input and the external barrel power input at the same time. The maker found an ordinary SCART-to-HDMI box unstable in one 80-column game while GBS-Control remained stable.

Publishes an experimental 1024 KB plus 64 KB SRAM expansion board for the Atari 600XL and 800XL.

The author labels the April 2025 post UNDER WORK and calls it a placeholder. A KiCad archive containing the stated schematic and Gerbers is downloadable, but the page provides no bill of materials, assembly guide, firmware, electrical test results, completed installation report, or explicit license. Treat it as an unfinished engineering project for experienced builders, not a validated kit.

A source-available relay board that cuts the C64's 5 V supply above about 5.6 V.

The public repository was last updated in January 2020 and PCBWay retains a bare-board order route for Revision E. No explicit hardware license is published, so this is source-available rather than licensed open hardware. Revisions C and D require a documented bridge between DIN pins 4 and 5 for supplies that place 5 V on the alternate pin; Revision E incorporates that fix. A separate builder found severe thermal drift in an older Console5-derived prototype and called that build unfit for protection. Test any completed board's trip point and stability under realistic load and temperature before relying on it.